Freightliner knows the Coronado doesn't appeal to everyone. Marketing research shows it's more popular among younger owner-operators and that western owner-ops tend to prefer the Classic XL.

As one of the older drivers, I confess I was a little less than enthusiastic when I first saw it, but it has grown on my tired eyes over the past few years. As a widening driver, I do appreciate the room between the seats as well as the easy access into the cab. I fit pretty comfortably into the Coronado, and that was really my first impression.

Coronado isn't exactly a new Freightliner model, but they remain fairly rare birds in Canada. Typically, they're built on a longer chassis than is allowed in Canada, that is; something less than 244 in. With the long hood and the 70-in. sleeper, it just won't work with our archaic length rules unless the frame is trimmed just a little.

The truck I drove around Oregon had a rather generous rear deck -- more room than you'd really need -- and Jennifer Harris, on-highway marketing manager at Freightliner, tells us that's where they make the 25-in. cut to get the trucks legal for Canada.

Canadians wishing to install an APU or a genset might have to give up a little fuel capacity or some under-cab storage space in the form of the right-hand-side toolbox.

There are several design features worth mentioning, like the two-piece windshield -- it's cheaper and easier to repair than a one-piece window.

And the fenders are bolted to the hood, not molded, meaning they can be replaced inexpensively without major surgery to the hood. The headlights are a snap to replace, and you don't need as much as a screwdriver to do it.

In the cab, you'll find the power-distribution module located on the topside of the passenger dash, making it awfully easy to reset a breaker or change a fuse. The HVAC fan has -- get this -- eight speed settings. And the climate-control system in the cab is separate from the sleeper, giving occupants of both full control.

Creature Comforts:

Freightliner has always done a good job with the driver environment, I think, and Coronado is certainly no different. From the moment I put it in gear and left the Test Engineering center in Portland, I felt at home behind the wheel -- especially with the pedal-shifter-steering wheel arrangement. This is where you spend the bulk of your time in a truck, so it needs to be right for you. It couldn't be much righter for me.

The 70-in. sleeper is worth crowing about a little, too. Getting up to the upper bunk wasn't too much trouble, and the upper windows open for ventilation. Where I had trouble was getting down. There's this seatbelt-type catch right dead center on the front edge of the platform, which, when a guy attempts to slide off of, tends to grab at certain body parts… I'll say no more, but be cautioned.

There's a nifty little pull-out desk built into the driver's side cabinet, and the cabinet top is a non-slip surface that really is non-slip. There's lots of room back there for your duds and other stuff as well, and it's pre-wired for an entertainment center, fridge, and possibly a microwave if there's an inverter installed.

Two-Lane Time:

Oregon is home to some really interesting driving environments, and what a truck to be driving them in. I ran east out of Portland along I-84, past The Dalles, to Biggs, where I cut south on U.S. Highway 97. While the scenery along I-84 is nothing to sneeze at, the road didn't offer much of a challenge to the Coronado. U.S. 97 was better in that it was two-lane, but darned good two-lane.

The front-end geometry on the truck made U.S. 97 feel as smooth and straight as an Interstate anyway. Even the twists and turns were rendered nearly routine by the TRW PCF 60 steering gear and the Freightliner front suspension. I'd look for that setup on any truck I was buying.

The front axle is set back slightly -- 35.7 in. -- from the bumper, which improves the smoothness of the ride without any side effects in handling. That setup also yields a 50-degree wheel cut, which really narrows the turning radius.

The real test of the steering system's stability came later when I snuck down state highways 138, 230, and 62 around Crater Lake National Park and down to Grant's Pass. That's an awesome road for anyone who really likes to drive and happens to be driving a truck that likes to be driven.

There are some pretty tight curves and steep grades down there, but all were laid flat and straight by the Coronado and its standard 1,650-lb-ft Series 60 (Cat's C15 is optional).

Heading north on I-5 toward Portland, one finds some long grades. Again, the 515-hp Series 60 took them in stride and all the while the cooling system did its thing without the aid of the big fan.

Coronado is available in a day-cab configuration, or with a choice of two sleepers: a 70-in. mid-roof or the full-height raised-roof model. When the 2008 models hit the street early this year, you won't see any changes to the outward look of the truck, despite a radiator that has grown from 1,500 to 1,900 sq in. The DPFs will be frame mounted, and the exhaust stacks will be routed much the same as they are now.

Demographics aside, any driver would find the Coronado a good compromise between aerodynamics and traditional styling. The bright trim and chrome accents on the outside might appeal to a younger buyer, but like George Bernard Shaw said, "youth is wasted on the young."